• EMAIL : response@aryaelectronics.net
  • Call Now : +91-9552508345
  • Find Us : Pune

SMPS Battery Chargers

Home / SMPS Battery Chargers


SMPS Battery Chargers Overview :

We are Manufacturer, Supplier, Exporter, Designer, Services Provider of SMPS Battery Chargers, Industrial Battery Chargers and our set up is situated in Pune, Maharashtra, India.

A switched-mode power supply (SMPS) is an electronic circuit that converts power using switching devices that are turned on and off at high frequencies, and storage components such as induct-or or capacitors to supply power when the switching device is in its non-conduction state.

Arya Electronics SMPS battery charger are pure DC battery chargers are microprocessor controlled based for fast and accurate charging of all deep-cycle batteries. A wide AC input voltage range enables proper delivery of a full three-stage charge, even when charging from less than perfect quality grid power or generator power.

SMPS Battery Charger series are fixed output voltage, current limited battery chargers specially designed for permanent connection to Genset starter batteries. They maintain the batteries fully charged, without overcharging. The chargers are designed in switch mode technology.

  • BATTERY CHARGER : 12V 6A
  • BATTERY CHARGER : 12V 10A
  • BATTERY CHARGER : 24V 5A
  • BATTERY CHARGER : 24V 10A

BATTERY CHARGER FOR ENGINE START APPLICATIONS SUITABLE FOR CHARGING:

  • 12 V/24V-60AH,
  • 12 V/24V-90AH BATTERIES

Specifications:

Input Voltage – 150 – 275V AC
Output voltage – 12V/24V
Float Mode – 13.2 V DC Boost Mode 13.8 V DC
Charging current in boost mode – 6 A / 10A
Charging current in float mode – 0 to 2.5 amps
Operating Temperature – 0 TO 70 DEG C


SMPS Battery Chargers

Protections :

Input under voltage – Cut off level 140 VAC. Turn on voltage 160 VAC
Input over voltage – 280 V AC units shuts off if voltage goes above this value
Output short circuit and overload Battery reverse polarity - Continuously protected
Annunciation Potential free NO /NC contact for charger - On / Fail indication
Indication - Mains On, Float, Boost, and Battery Reverse
Ripple and noise - 150 mv p-p
Isolation between - Input & Output 2000 V AC
Input & Earth - 1500 V AC
Output & Earth - 1500 V AC
Dimensions - L*B*H 170*120*50 mm
Mounting - Wall mounting type